Tech Support 1.888.4DMP TECH

Tech Support is currently closed

TECH SUPPORT FAQ

     

New DMP Technician's Tools

DMP is pleased to release several new products that are sure to benefit you and your technicians.

These new products include:
  • V-4000-Plate-1: White steel camera mounting plate for use with electrical single gang boxes and the SecureCom Wireless Bullet or Dome Cameras. 
    • If you have ever installed cameras in a new construction environment, where all the low voltage wiring already has Single Gang Boxes for the wire run, you know that it's not easy to mount the cameras to that box. Even when you do a nice mounting, the camera bezel does not cover the edges of the box which makes it difficult to make a professional installation. Introducing the mounting plate that solves all that - the DMP V-4000-Plate-1. This is a white steel camera mounting plate for use with electrical single gang boxes and the SecureCom Wireless Bullet or Dome Cameras. Simply use the included screws to connect the the mounting plate to the existing electrical box, then mount up the cameras to the threaded pems that are aligned for either camera. Your camera installations just got better looking and faster to install.
 
  • 351ONQ: Mounting plate used when installing a XR150/XR550 panel, XT30/XT50 panel, 714-8 expander, or 714-16 expander into an existing ONQ structured wiring enclosure.
 
  • 351PRI: Mounting plate used when installing a XR150/XR550 panel, XT30/XT50 panel, 714-8 expander, or 714-16 expander into an existing PRIMEX structured wiring enclosure
 
  • Accessory Pack: Traditional Accessory Pack has been updated with several new items including:
    • One Model 333 Noise Suppressor
    • Three Model 309 3.3K EOL Resistors with Wire Leads
    • Three Model 308 10K EOL Resistors
    • One 128MB Micro SD Card
    • One DMP 1GB USB Drive
    • One Panel Key
    • One Model 300 Panel Tamper Harness
    • Two .800" Tamper Springs
    • Two 1.25" Tamper Springs
    • Two .200" Tamper Springs
    • Two .900" Tamper Springs

For more information, please view the attached documents: